does anyone have standard 2.0 pinto in bits at the moment?,

i;m after the ID of the inlet ports(where the inlet manifld meets the head)

so i can get parts together for a manifold.

cheers
Ray

34mm dia

38 mm on the later 2 litre heads.

Taking a horizontal measurement at the very face of the head - the port tapers in.

2.0L Unleaded std. 37.20mm
2.0l EFI 38.00mm

Also measured an early head that I have and that measured in at 38.00mm

Cheers

Andrew

I was under the impression that there were 2 different port sizes on the 2 litre pinto (I remember reading it in one of the pinto tuning books). Not sure when the larger one became std though... or even if it was std

I have only used the term standard above to identify that its not an unleaded EFI head.

I have not seen a 2.0L head with a smaller port than 37/38mm - be interested to know what 2.0L has the 34mm port size.

Cheers

Andrew

I thought the injection heads had smaller ports.

I know they are preferred due to better port angle but I also thought they had smaller ports as the originals were too large as standard.