Does anyone happen to know what the thread size is for the nuts that hold the weber to the inlet manifold on a kent 1600 engine?
Thanks
Dave

I reckon 5/16 unf, dont think they had gone to 8mm that long ago,
Steve,

^^^ wot he says. 5/16 UNF at the nut end and 5/16 UNC in the manifold. same for the cylinder head.


oh, and if anytone know where you can get the studs cheap, please let me know.

incidentally, anyone know why there are different part numbers listed for the exhaust and inlet studs and different to the manifold studs? surely one size will fit them all?

[Edited on 8/2/07 by 02GF74]

They are different lengths, can't remember off the top of my head which ones are longer though

quote:

---

Originally posted by 02GF74
oh, and if anytone know where you can get the studs cheap, please let me know.

---

...for your input everyone.

Dave