Thinking about it
|
| posted on 2/3/09 at 03:24 PM |
|
|
spigot bearing
How far should this be set into the end of the crankshaft?
Type 9
1600CVH (XR3i type)
All the way?
[Edited on 2/3/09 by Thinking about it]
[Edited on 2/3/09 by Thinking about it]
|
|
|
|
|
carlknight1982
|
| posted on 2/3/09 at 03:59 PM |
|
|
i never consider ed that, i need to know to but for a zetec
|
|
|
whitestu
|
| posted on 2/3/09 at 04:22 PM |
|
|
I tapped mine in as far as it would go on my Zetec. Seems fine so far.
Stu
|
|
|
big_wasa
|
| posted on 2/3/09 at 04:33 PM |
|
|
I put mine in untill it was flush with the end of the crank. The little rubber grease seal wants to be on the out side.
|
|
|
UncleFista
|
| posted on 2/3/09 at 04:51 PM |
|
|
You can tell when it's in fully, the sound (of the hammer on the drift) changes and there's no "give" you'll know when
it's done 
Tony Bond / UncleFista
Love is like a snowmobile, speeding across the frozen tundra.
Which suddenly flips, pinning you underneath.
At night the ice-weasels come...
|
|
|
