scootz
|
| posted on 8/4/09 at 06:58 PM |
|
|
Turbo On Carbed Bike Engine
What would be required to install a turbo on a bike- engine with flat slides?
I'm thinking:
Intake pipe and filter
Turbo (obviously)
Header / turbo flange
Link pipe to plenum
BOV
Exhaust pipe
Anything else?
Some more Q's...
Is an intercooler essential for a low boost turbo?
Where about should the BOV be situated?
Cheers!
|
|
|
|
|
A1
|
| posted on 8/4/09 at 07:17 PM |
|
|
check out holeshot racing, been thinking of it myself
|
|
|
mark chandler
|
| posted on 8/4/09 at 07:28 PM |
|
|
higher pressure fuel pump, rising rate fuel pressure valve thingy, off boost 3psi fuel pressure, 12 psi boost 15psi fuel pressure required.
Something off an old renault 5 turbo maybe.
Regards Mark
|
|
|
flibble
|
| posted on 8/4/09 at 07:47 PM |
|
|
You'd need a box around your carbs too I think, something to equalize the pressure to the floats, unless they're already 'pressure
proof' carbs.
I could be wrong, tis what my old blade had to have though 
Ooh, and a sandwich plate with an oil takeoff from the filter - for the turbo feed.
[Edited on 8/4/09 by flibble]
|
|
|
Kev99
|
| posted on 8/4/09 at 07:59 PM |
|
|
have a look at this site it has a lot of good infomation on it
link
|
|
|
scootz
|
| posted on 8/4/09 at 08:03 PM |
|
|
Cheers peeps!
|
|
|
scootz
|
| posted on 9/4/09 at 07:57 AM |
|
|
PS - is an intercooler an essential?
|
|
|
