trialsman
|
| posted on 21/5/09 at 02:57 AM |
|
|
GSXR can
Well I decided to buy a GSXR muffler off of ebay. It is in great shape and not any heavier than my existing muffler. Has anyone ever taken off the
outlet on one? I want to put a 90 deg elbow on the outlet but the three allen screws are welded to the plate. I don't want to grind off the
welds if I can't get to the inner pipe to weld on an elbow. I don't want hot exhaust going on the fender and tire. Russ
|
|
|
|
|
mark chandler
|
| posted on 21/5/09 at 08:42 AM |
|
|
I took one apart, knock off the welds and screws do undo revealing a steel blank below, raised tabs with retaining nuts that the plate screws to.
The end cap is something special though, I could not weld it back using TIG so if you screw this up you are stuffed.
Rather that cut the welds on the screws I suggest you drill out and replace with allen bolts.
Regards Mark
|
|
|
omega 24 v6
|
| posted on 21/5/09 at 11:35 AM |
|
|
i put an elbow on mines. As said you cannot weld it. send me your email and i'll send you some pics,
If it looks wrong it probably is wrong.
|
|
|
ReMan
|
| posted on 21/5/09 at 04:54 PM |
|
|
Any chance of a public picture chaps?
I assume your referring to a Bandit can? 3 stud flange fixing?
|
|
|
