mad4x4
|
| posted on 28/6/09 at 06:05 PM |
|
|
TINTOP: Zetec Gaining Revs
Ok having a little problem with my Tintop (1.8 MkI Focus) .
When driving and I dip the clutch the engine seems to rev up. Also when I lift off the throttle it seams to take an age to drop revs.
Have check Throttle cable and linkage and they are all free.
All suggestions welcome..
Point to note I had the Air box open today and cleaned the filter - car seems a wee bit better. MAF looks clean enough.
Scot's do it better in Kilts.
MK INDY's Don't Self Centre Regardless of MK Setting !
|
|
|
|
|
prawnabie
|
| posted on 28/6/09 at 06:07 PM |
|
|
Idle control valve sticking wide open?
|
|
|
mad4x4
|
| posted on 28/6/09 at 07:18 PM |
|
|
Were is it ??
Scot's do it better in Kilts.
MK INDY's Don't Self Centre Regardless of MK Setting !
|
|
|
Danozeman
|
| posted on 28/6/09 at 08:24 PM |
|
|
I had one do the same. Put a TPS on it and it solved it.
Also check idle control valve and make sure the throttle body is sealed on the manifold properly.
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
mad4x4
|
| posted on 29/6/09 at 06:39 PM |
|
|
UPDaTE :
Went out and had a look today and found that the throttle cable linkage was sticking between the pedal and the throttle on the engine. So when I was
lifting off it would take a few second for the cable to slowly slide back to zero reves
So new cable from FORD me thinks. Get tomorrow and will let you know
Scot's do it better in Kilts.
MK INDY's Don't Self Centre Regardless of MK Setting !
|
|
|
