franky
|
| posted on 21/8/09 at 05:47 PM |
|
|
shortened bike sump help....
I've got a zx12r engine..... i've also got a short baffled sump to go with it, its got a modified pick-up(the hard plastic bit). However
do I need to sort out the other feed(long rubber hose) that would normally sit in the sump? Also with this hose I take it that it should sit right at
the bottom of the sump?
Cheers.
|
|
|
|
|
eccsmk
|
| posted on 21/8/09 at 05:56 PM |
|
|
i shortened the hose on mine so there was about a 5mm gap and cut a square out of it (the same as the origional end of the hose)
|
|
|
Moorron
|
| posted on 21/8/09 at 06:11 PM |
|
|
same here, cut it down but add the notch into it to let the oil in/out. i just took some wire snips to it and put a 'v' into it.
im too lazy to make a square! lol
Sorry about my spelling, im an engineer and only work in numbers.
|
|
|
