andy188
|
| posted on 15/10/09 at 07:47 PM |
|
|
zetec ignition using cvh wirring
hi, can i use my cvh 1800 carb ignition wirring for my winter upgrade to a zetec, have looked at the 1400,1600cvh wirring sugestions from this and
other sites, both wirring diagrams look very simular except some wires from ecu module to distributor/coil pack, any thoughts, suggestions, thanks.
|
|
|
|
|
big_wasa
|
| posted on 15/10/09 at 07:54 PM |
|
|
My 1.8 cvh has a coil and dizy how would you replicate that on the zetec ?
If on a very tight budget you could use the esc modual from a 1.1~1.3 endura Fiesta / Escort.
I ran a cvh on one for months ive also run zetecs and alsorts with a 36-1 trigger wheel. Its not perfect for a zetec but its better than
nothing.
 
|
|
|
whitestu
|
| posted on 15/10/09 at 08:05 PM |
|
|
I agree that you won't be able to use cvh carb ignition on a Zetec.
Even if you could I wouldn't bother. A Megajolt would be the best route if using carbs on your Zetec.
Stu
|
|
|
big_wasa
|
| posted on 15/10/09 at 08:16 PM |
|
|
yep mjl would be a good step up
its all down to cost.
|
|
|
andy188
|
| posted on 15/10/09 at 08:26 PM |
|
|
zetec ignition using cvh wirring
thanks for the replies, does the esc module do advance and retard,
i have allso heard from local banger racers that use mk1 moneo ecu, ??? on wirring,
have looked at mj, im not good with pc's, maps etc.
|
|
|
big_wasa
|
| posted on 15/10/09 at 08:34 PM |
|
|
yep does the advance.
Mk1 (EEC IV) ecu is now rare and sort after as its a pre pats ecu.
Ive wired a few of them up. If going that route you may aswell run the injection aswell. Ecu is 60 pins so lots of wiring.
I am now working on the EEC V Pats1 ecu's They are 104 pin so even more wiring but doable.
Have a butchers at some of my vids
http://www.youtube.com/watch?v=Pxq4ks2Us_U
Give me a shout if you need any help on running a zetec on budget. 
[Edited on 15/10/09 by big_wasa]
|
|
|
whitestu
|
| posted on 15/10/09 at 08:50 PM |
|
|
MJ is pretty easy to wire. I haven't messed about with maps much - I just used someone else's.
Stu
|
|
|
andy188
|
| posted on 15/10/09 at 09:09 PM |
|
|
zetec ignition using cvh wirring
youtube looks great is it fitted yet, thanks for the offer of help with the zetec on a budget, will look further into wirring/getting parts for both
of the suggested ignition types (esc and mk1 mondoe).
was hopeing to go bike carbs for fuelling, ??? on space for injection system.
thanks andy
|
|
|
