big-vee-twin
|
| posted on 1/11/09 at 08:57 AM |
|
|
CLUTCH RELEASE/THRUST BEARING
I'm going to be mating a type 9 to a Zetec engine.
I want to replace the thrust bearing before I do this, which is the best to use the standard Sierra one or I understand the Capri one may be a better
option.
Also how much play is acceptable on the input shaft just want to check.
Duratec Engine is fitted, MS2 Extra V3 is assembled and tested, engine running, car now built. IVA passed 26/02/2016
http://www.triangleltd.com
|
|
|
|
|
big_wasa
|
| posted on 1/11/09 at 09:21 AM |
|
|
You want a longer bearing such as the QH cct133 there was a guy selling them on ebay but I can not find it at the mo'
The standard bearing on a Fwd cover plate will reduce clutch travell by about 20mm
|
|
|
lotusmadandy
|
| posted on 1/11/09 at 09:22 AM |
|
|
CT 133
Off a capri is longer than the sierra one,
if dont you will run out of clutch travel.
Andy
|
|
|
big-vee-twin
|
| posted on 1/11/09 at 11:18 AM |
|
|
Thank you
Duratec Engine is fitted, MS2 Extra V3 is assembled and tested, engine running, car now built. IVA passed 26/02/2016
http://www.triangleltd.com
|
|
|
