Tris
|
| posted on 8/5/10 at 10:57 AM |
|
|
ZX14 Gear selector length ?
Morning All,
I am currently trying to fit one of AB Performances paddle shift gear selectors, via a pull-push cable, to a ZX12 engine.
Ive been told however that the leaver arm on the gear selector that comes out of the engine is not long enough, and that i need the arm off a ZX14
(guessing that a longer throw is required).
Does anyone either know where i could get one of these from ?. OR, does anyone have a ZX14 motor which they can measure the length of the arm (between
piviot points) for me ?
Cheers
Tris
|
|
|
|
|
skippad
|
| posted on 8/5/10 at 03:27 PM |
|
|
the selector bar on mine is 100mm.
It's got 2 holes cable/rod end for adjustments.
Remember, longer the bar, longer the throw.
Dave
|
|
|
