splitrivet
|
| posted on 16/5/10 at 01:34 PM |
|
|
Cylinder honer tips
As per subject any hard and fast rules using a drill mounted cylinder honer, length of of time to run it in the cylinder etc, thanks guys.
Cheers,
Bob
I used to be a Werewolf but I'm alright nowwoooooooooooooo
|
|
|
|
|
omega0684
|
| posted on 16/5/10 at 02:00 PM |
|
|
dont go slowly or stay on the same spot, move quickly up and down the cylinder for a few seconds, job done really.
I love Pinto's, even if i did get mine from P&O!
|
|
|
splitrivet
|
| posted on 16/5/10 at 02:28 PM |
|
|
Cheers spud.
I used to be a Werewolf but I'm alright nowwoooooooooooooo
|
|
|
paulf
|
| posted on 16/5/10 at 09:02 PM |
|
|
As above but also make sure you apply plenty of lubricant either diesel, paraffin or white spirit.Run the drill at a medium speed and if the pressure
is adjustable use plenty of pressure.
Paul
|
|
|
.jpg)
