johnq
|
| posted on 16/1/11 at 03:49 PM |
|
|
CROSSFLOW
crossflow to type9, what parts are needed ie clutch release bearing etc, any part nos etc,thanks in advance
looks like rain again
|
|
|
|
|
rusty nuts
|
| posted on 16/1/11 at 04:32 PM |
|
|
IIRC I use an early 1600 Sierra 5 speed clutch which copes with nearly 130BHP and 115lb ft torque
|
|
|
snapper
|
| posted on 16/1/11 at 06:44 PM |
|
|
The crossflow used several Ford boxes, luckily the bell housing bolt pattern is the same, the clutch plate splines are not.
Sooo you need the Escort clutch that went on a Crossflow with the early Type 9 4 speed box.
Early type E boxes had 20 spline clutch plates, type 9, 23 spline
Hope that helps
I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)
|
|
|
rusty nuts
|
| posted on 16/1/11 at 07:11 PM |
|
|
Like I said , early Sierra 5 speed clutch. Correct diameter plate to fit gearbox splines and correct diameter cover to fit the flywheel. I'tl
cost you more if you mix and match
|
|
|
.jpg)
