IainL
|
| posted on 22/1/11 at 04:39 PM |
|
|
Fireblade to ETB Sensors
I've just tried to fit both the Temp Sensor and the remote oil pressure sensor supplied with my ETB Digidash but when I tried to screw them in
after a couple of turns they started to get tight, I therefore gave up and put the old ones back in for the time being.
The engine is a Fireblade 919 and then sensors supplied by ETB both have 1/8 NPTF threads.
Does anyone know what thread size the sensor are fitted to the Fireblade engine?
Or can ETB supply different sensors?
Or am I just worrying about nothing, don't want to strip the threads in the engine
Cheers
IainL
|
|
|
|
|
bigfoot4616
|
| posted on 22/1/11 at 06:31 PM |
|
|
can't remember what the threads where but on mine the flexi hose ETB supplyed for the oil pressure sensor was correct and fitted correctly.
the coolant temp sensor was like you say yours are so i used thread lock and sealand just nipped it up a little more when it started to tighten. have
had no problems for 2 years
|
|
|
