liam.mccaffrey
|
| posted on 24/3/11 at 08:09 AM |
|
|
Sierra CV joints
Anyone know what the angular limits are on a sierra CV joint. I'm using one in my middy but with much shorter driveshafts and I'm worried
about popping the joint.
Can I purchase wide angle joints?
Any advice greeatfully accepted.
Build Blog
Build Photo Album
|
|
|
|
|
minitici
|
| posted on 24/3/11 at 08:25 AM |
|
|
Berrisford easy motion
joints
Easy Motion Race Cage (100mm CV). Replaces standard CV cage with this high strength race cage. When used with High Angle flange (BCC5101) these
products will increase the amount of driveshaft angle from 17 degrees as standard up 27 degrees of "+ & -" movement. Therefore
allowing you too use longer suspension travel.
Also - If you use Berrisford shafts as well, these do not use an inner circlip and have a longer splined section to allow the shaft to slide through
the CV joint for greater travel.
[Edited on 24/3/11 by minitici]
|
|
|
