Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Weber DCOE 151 pump jet leak
Westy1994

posted on 29/7/12 at 09:49 PM Reply With Quote
Weber DCOE 151 pump jet leak

Hi all,

My car has done this for years, but getting annoyed with it now and need to get it sorted out.

Fuel drips from just one pump jet nozzle when engine is stopped and no fuel pump running - still drips after an hour of it being run. Car runs fine and tick over is perfect, just need to get this leak sorted out as I hate wasting the fuel.

I have tried swapping the jets from one choke that does not leak and it still does the same thing, I don't mind getting a service kit, but would be nice to know why it's doing this in the first place.

Anyone had the same thing happen, and if so, how did you sort it?.

Cheers

Rich

View User's Profile Visit User's Homepage View All Posts By User U2U Member
Xtreme Kermit

posted on 29/7/12 at 09:54 PM Reply With Quote
Sounds odd... Could it be the float valve leaking and causing the fuel level to go too high?
View User's Profile View All Posts By User U2U Member
Westy1994

posted on 29/7/12 at 10:05 PM Reply With Quote
Sounds feasible, but it's just one choke that it happens on. If it were a faulty float level, it would be leaking from both chokes on the same carb, sadly it's not. The fuel can be seen dripping from the brass jet that drops down inside the intake throat., similar to a dripping tap in your kitchen.

The last oil change I did, the oil was so thin and smelt very badly of petrol, now I know why.

View User's Profile Visit User's Homepage View All Posts By User U2U Member
jollygreengiant

posted on 29/7/12 at 10:55 PM Reply With Quote
I would have said float level too. As for dripping down from just one, well probably that just reflects that they are not perfectly level in-situ.


JMTPW.





Beware of the Goldfish in the tulip mines. The ONLY defence against them is smoking peanut butter sandwiches.

View User's Profile View All Posts By User U2U Member
Westy1994

posted on 29/7/12 at 11:10 PM Reply With Quote
Again, I would have said possible, except the choke concerned is is not on either end and the manifold is a one piece affair that serves all chokes, if looking at the front of the engine cylinder 1 would be first, the leak is on cylinder 3.
View User's Profile Visit User's Homepage View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.