Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Type 9 thrust bearing
se7ensport

posted on 24/9/19 at 08:53 PM Reply With Quote
Type 9 thrust bearing

Simple initial question, with a cable clutch is the thrust bearing supposed to touch the clutch plate fingers all the time and therefore rotate with the engine, or is it supposed to sit a number of mm away from the fingers when the clutch is not pressed.
View User's Profile View All Posts By User U2U Member
rusty nuts

posted on 25/9/19 at 06:54 AM Reply With Quote
Adjust the cable so that the clutch pedal has a small amount of play, approx 19mm ,before it starts to compress the clutch .Another way is to adjust the cable so there is 2 to3 mm play on the clutch arm where the cable attaches
View User's Profile View All Posts By User U2U Member
snapper

posted on 25/9/19 at 09:07 PM Reply With Quote
Thrust bearing touches the fingers, the play described is simple take up of clutch pedal movement and some cable flex





I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)

View User's Profile View All Posts By User U2U Member
se7ensport

posted on 25/9/19 at 11:11 PM Reply With Quote
So the thrust bearing spins at the same speed as the engine rotates.
View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.