CairB
|
| posted on 28/1/06 at 06:13 PM |
|
|
Crane cams, Eagle forged rods, SuperTech forged pistons
I'm considering a few 'technical adjustments', has anyone any experience of the items in the subject line?
|
|
|
|
|
Jon Ison
|
| posted on 28/1/06 at 07:06 PM |
|
|
Crane cams are very respected, never used those rods or pistons though.
|
|
|
Volvorsport
|
| posted on 28/1/06 at 07:35 PM |
|
|
id say for the price you pay for those will almost double your smiles . go for it .
the eagle rods are pretty good , being H beam .
if its a cutsom application - try to pick the lightest piston with the the highest pin bore to allow a good sized rod in there . Revs , revs , revs
with that sort of setup .
Im using a similar approach but with stuff that can survive high boost pressures , so its always wise to pick for your particular application .
www.dbsmotorsport.co.uk
getting dirty under a bus
|
|
|
