MikeR
|
| posted on 19/3/06 at 12:10 AM |
|
|
putting 10 to 20 degree bend in stainless
Need to make a pipe to connect my manifold to my can. Needs about a 10 to 20 degree bend in 1.5mm 2" stainless.
Any suggestions how i do it?
|
|
|
|
|
ed_crouch
|
| posted on 19/3/06 at 12:15 AM |
|
|
Oxy acetylene with a big carburising flame and heat it till its cherry red, then bend it.
Or take it to an exhaust specialist and get it bent properly.
Ed.
I-iii-iii-iii-ts ME!
Hurrah.
www.wings-and-wheels.net
|
|
|
suparuss
|
| posted on 19/3/06 at 08:45 AM |
|
|
pack it with sand first if you are using oxy/acet or itll kink.
ive got a guide on sand bending somewhere if youre interested.
[Edited on 19/3/06 by suparuss]
|
|
|
Fred W B
|
| posted on 19/3/06 at 08:52 AM |
|
|
Buy a 2" swept elbow from a dairy pipe supplier and cut out what you need
Cheers
Fred WB
|
|
|
