02GF74
|
 posted on 28/3/06 at 09:11 AM |
|
|
accelerator bunmp stop - ideas
Lookoing for ideas to make a bump stop for the acceleerator pedal; when it is fully depressed  , the carbs limit its travel - not good.)
Don't know the best way but either could make a bracket at the top of the pedal to limit it or a bolt in the foot well.
Ideas?
|
|
|
|
|
zxrlocost
|
| posted on 28/3/06 at 09:22 AM |
|
|
L bracket riveted through floor with a hole in the L put a nut and bolt through then you can adjust
chris
|
PLEASE NOTE: This user is a trader who has not signed up for the LocostBuilders registration scheme. If this post is advertising a commercial product or service, please report it by clicking here.
|
Mix
|
| posted on 28/3/06 at 10:29 AM |
|
|
Bolt in the footwell would probably allow for easier fine adjusrment as it would be further away from the pedal pivot.
Mick
|
|
|
Hellfire
|
| posted on 28/3/06 at 04:22 PM |
|
|
Threaded run with an L piece so's you don't have to mount on the radius steel.
Like this here on 1st December.
Steve
|
|
|
