whitestu
|
| posted on 2/9/06 at 09:35 AM |
|
|
Zetec Flywheel
Anyone know if a 1.8 CVH flywheel will fit a 1.8 Zetec?
|
|
|
|
|
lsdweb
|
| posted on 2/9/06 at 09:40 AM |
|
|
Yes
Direct fit but you may need to dril the bolt holes out by a mm
Wyn
|
|
|
scotty g
|
| posted on 2/9/06 at 09:55 AM |
|
|
Alternatively why not use a 1.8 zetec flywheel?
|
|
|
Surrey Dave
|
| posted on 2/9/06 at 10:09 AM |
|
|
If you use a CVH flywheel / clutch do you still need the ct133 release bearing?
does anyone know the weights of the CVH and Zetec 1800 flywheels .
|
|
|
whitestu
|
| posted on 2/9/06 at 10:36 AM |
|
|
quote:
Alternatively why not use a 1.8 zetec flywheel?
Haven't got one, but do have a 1.8 CVH one with a new clutch.
If the zetec is better I'll get one but if no difference might as well drill out the holes on the cvh one.
|
|
|
lsdweb
|
| posted on 2/9/06 at 11:36 AM |
|
|
Having no crank pickup is your only problem with the CVH one
|
|
|
coozer
|
| posted on 2/9/06 at 01:22 PM |
|
|
quote:
Originally posted by lsdweb
Having no crank pickup is your only problem with the CVH one
Unless its from an EFI model...
1972 V8 Jago
1980 Z750
|
|
|
whitestu
|
| posted on 2/9/06 at 01:45 PM |
|
|
What about fitting the CVH crank pulley onto the zetec as this has a pick up on it?
Would need to make a mount for the sensor but that should be quite easy.
|
|
|
lsdweb
|
| posted on 2/9/06 at 09:52 PM |
|
|
I fitted part of a CVH trigger wheel onto the Zetec pulley (can't remember why!) - looked like
this
Wyn
|
|
|
whitestu
|
| posted on 4/9/06 at 08:43 AM |
|
|
The standard CVH pulley fits straight on to the Zetec crank, but unfortunatley the pulley is then too far forwards to drive the water pump.
I guess it is probably going to be easier to get a Zetcec flywheel.
Should have bought an engine with one on in the first place!
Cheers
Stu
|
|
|
