rayward
|
| posted on 7/2/07 at 02:37 PM |
|
|
pinto inlet sizes???
does anyone have standard 2.0 pinto in bits at the moment?,
i;m after the ID of the inlet ports(where the inlet manifld meets the head)
so i can get parts together for a manifold.
cheers
Ray
|
|
|
|
|
jos
|
| posted on 7/2/07 at 03:18 PM |
|
|
34mm dia
.: Motorsport / motor racing circuit / track wall art Apex Traxs :.
|
|
|
flak monkey
|
| posted on 7/2/07 at 03:36 PM |
|
|
38 mm on the later 2 litre heads.
Sera
http://www.motosera.com
|
|
|
Andy S
|
| posted on 7/2/07 at 07:05 PM |
|
|
Taking a horizontal measurement at the very face of the head - the port tapers in.
2.0L Unleaded std. 37.20mm
2.0l EFI 38.00mm
Also measured an early head that I have and that measured in at 38.00mm
Cheers
Andrew
|
|
|
flak monkey
|
| posted on 7/2/07 at 07:30 PM |
|
|
I was under the impression that there were 2 different port sizes on the 2 litre pinto (I remember reading it in one of the pinto tuning books). Not
sure when the larger one became std though... or even if it was std 
Sera
http://www.motosera.com
|
|
|
Andy S
|
| posted on 7/2/07 at 08:53 PM |
|
|
I have only used the term standard above to identify that its not an unleaded EFI head.
I have not seen a 2.0L head with a smaller port than 37/38mm - be interested to know what 2.0L has the 34mm port size.
Cheers
Andrew
|
|
|
TangoMan
|
| posted on 7/2/07 at 10:50 PM |
|
|
I thought the injection heads had smaller ports.
I know they are preferred due to better port angle but I also thought they had smaller ports as the originals were too large as standard.
Summer's here!!!!
|
|
|
