EXHAUST MANIFOLDS
I originally cobbled together the manifold for my Pinto using an old 4-2-1 manifold and some stainless off cuts. Some of the welds were decidedly
agricultural, and I eventually had one made out of stainless, by Andy Woods who is based in Shoreham. I'm very pleased with the result, and
would post a picture but the last time I did that it was too large and took up most of the page!!
For those of you who aren't too far from Shoreham, and are considering having a manifold made, Andy is contactable on: 07961 901580.
Regards, Ian.
|
