theconrodkid
|
| posted on 6/5/06 at 04:39 PM |
|
|
zetec/t9 clutch
fitted a 1600 zetec clutch to the engine,to overcome the release bearing prob i knocked out the release lever pivot,tapped a thread and put a bolt
with 20mm spacer on,brings lever back to where it should be and there is enough bearing on the slider tube to stop it wobbling about 
who cares who wins
pass the pork pies
|
|
|
|
|
rusty nuts
|
| posted on 6/5/06 at 04:48 PM |
|
|
Sounds like a common sense answer to the problem , hope you put thread lock on the bolt
|
|
|
theconrodkid
|
| posted on 6/5/06 at 04:51 PM |
|
|
yup,locktite and a lock nut
who cares who wins
pass the pork pies
|
|
|
.jpg)
