bob
|
| posted on 24/9/06 at 06:46 PM |
|
|
Pinto temp sender thread size
I am in need of the thread size of the temp sender on a pinto block.
anyone know ? 
|
|
|
|
|
bob
|
| posted on 24/9/06 at 07:24 PM |
|
|
Just done a painfull search on the site and i am no better off,its either 1/4 NPT or 1/8 NPT.
I wish i had writen the size down when i asked the queston a couple or thre years back 
|
|
|
CairB
|
| posted on 24/9/06 at 08:14 PM |
|
|
Bob,
I think that its M10 fine.
Cheers,
Colin
|
|
|
bob
|
| posted on 24/9/06 at 08:49 PM |
|
|
Thanks colin, i'm pretty sure its not M10 fine.
I remember being told it was NPT though.
|
|
|
Fozzie
|
| posted on 24/9/06 at 09:41 PM |
|
|
1/8 NPT Bob.......
Fozzie 
DLT and I would like to publicly apologize to Bob for our abysmal Sunday info service....
Tee-hee
'Racing is Life!...anything before or after is just waiting'....Steve McQueen
|
|
|
CairB
|
| posted on 24/9/06 at 10:40 PM |
|
|
quote:
Originally posted by bob
Thanks colin, i'm pretty sure its not M10 fine.
I remember being told it was NPT though.
Sorry for my error Bob, the threads are close and I tapped the housing M10 fine to fit one on the d'tec.
|
|
|
bob
|
| posted on 25/9/06 at 07:24 PM |
|
|
No worries colin
I should have really put the thread size in my notes when building, the reason i'm asking the question this time though is not pinto related. I
want to keep the VDO temp gauge and sender i used with the pinto and plumb it into the zetec water works,hence needing to know the thread for the
inline adaptor.
I am now sure it is 1/8 NPT big thanks to conrodkid (again) and fozzie and DLT for making an effort
|
|
|
