Board logo

Oil Pressure Sender Zetec block thread
Hammy360 - 12/10/16 at 05:06 PM

Hi anyone know what thread the torx screw plug is in the 2.0 blacktop zetec block? I want to put to put my OPS in there, its about 6 inches to the left of the Ford Oil light sensor. I need to order an adaptor for my sender which is 1/8th NPT

Cheers Guys
Hammy

big_wasa - 12/10/16 at 06:33 PM

It's 1/4 npt the same as the oil pressure switch. Ford used it to feed the the turbo on the focus Rs.

[Edited on 12/10/16 by big_wasa]

Hammy360 - 12/10/16 at 06:42 PM

quote:
Originally posted by big_wasa
It's 1/4 npt the same as the oil pressure switch. Ford used it to feed the the turbo on the focus Rs.

[Edited on 12/10/16 by big_wasa]


Cheers Warren, Ill get on and order a 1/8th to 1/4 adaptor

tims31 - 24/10/16 at 03:22 PM

Is it ok to use this point on the Zetec block? I've just got my pressure sender through (1/8 NPT too) and was looking at having to buy an extension or t-piece adapter to replace the switch but if I can use the drilling next to it that would make things easier.

Just need to get an adapter then

[Edited on 24/10/16 by tims31]

Matth93 - 24/10/16 at 06:09 PM

I have just used it on my car and it's fine just got a adapter for the thread

Hammy360 - 25/10/16 at 12:08 PM

quote:
Originally posted by tims31
Is it ok to use this point on the Zetec block? I've just got my pressure sender through (1/8 NPT too) and was looking at having to buy an extension or t-piece adapter to replace the switch but if I can use the drilling next to it that would make things easier.

Just need to get an adapter then

[Edited on 24/10/16 by tims31]


Its totally OKmate

tims31 - 26/10/16 at 08:07 PM

Excellent, easier position to fit too, any ideas of the best place to get an adapter?