I wouldn't call this a garage clear out but after the embarrassment of offering a fellow builder a cable that's been hanging on the garage wall for the last ten years and it vanishing the day he comes to collect it. A good rummage has found some bits I had forgotten about / never new I had.

New Set of St170 ARP rod bolts, these are the 9mm bolts and wont fit the zetec. They are un used and in the packet. There is a bit of tape on one corner. May have had a read of the instructions.

Used Sierra cvh starter motor. Tried and tested on the st170 with a type 9 so good for the same or a Zetec E but not suitable if using an st170 exhaust manifold.

New Ford spigot bearing.

New Mt75 thrust bearing.

New Mtx75 thrust bearing.

I will take some pictures and add prices if there is any interest.

[Edited on 7/3/14 by big_wasa]

Bump, spigot bearing and starter sold. Any interest in the arp's ?