These are the Rally Design Hydra-Mech calipers - but are almost identical to Mk4 Golf ones used on many kits.

I bought these for my Westfield build, but due to the location of the hydraulic inlet, they just didn't fit - due to my kit being a Sierra SDV with 'fat' uprights.

They might fit other kits as the Westie uses a cast alloy rear upright that is quite bulky - but just be aware of where the inlet is - see pics.

They have never been used, just tried to fit them, so are as new apart from a couple of scratches on the springs.

I also have a set of hoses to fit and the 12mm banjos. The hoses have compression fittings but I preferred to get some made up by Hel with swaged ends, so these are now spare and FREE with the calipers.

The calipers are £49 +VAT each from RD but as I have kept the carriers, I'll take £30 + post for the pair of bare calipers and the hoses - which is less than the cost of the pistons and seals if you need them!









[Edited on 2/12/14 by kingster996]

[Edited on 2/12/14 by kingster996]

[Edited on 3/12/14 by kingster996]

Offer withdrawn due to a misunderstanding on my part. Apologies.

[Edited on 2/12/14 by liam.mccaffrey]

Blimey that was quick - first dibs are yours!

Still for sale - slight misunderstanding - so, just to clarify, there's no carriers included.

Thanks
Chris

ive just fitted a pair to westfield uprights what problems did you have ?

Probably down to my setup - 240 disc on a sierra SDV rear upright:



Replaced with some others - they were tight, but fit:



[Edited on 2/12/14 by kingster996]

Bart - looked at your pics - you have bigger carriers and smaller upright (ie std Westfield, as opposed to my SIerra SDV Westfield) - so these will fit most other setups I guess!

[Edited on 2/12/14 by kingster996]

If this is 2 calipers, just without the carriers, then could I have second (first?) dibs please?

Yes, U2U replied to James.