Hi all im on the hunt for a sierra diff mine was stolen :-(

my driveshafts are the push in type if that makes any difference?

Cheers

Ash

Hi

What ratio are you after? Also with push in shafts there were two sizes but the smaller size only appeared briefly in the earliest Sierras. I don't have the measurements to hand but I'm sure someone will post them.

not good that Ash!
i'll ask around too

I have a push in shaft Diff, complete with shafts. 3.9 ratio
I have the bearing carriers as well. The drums and back plates are not that good. However, for about £15 (for the coversion plates) you could convert to discs, which IMHO would be worth it!

Geoff i will keep you in mind cambridge is a bit of a drive. if nobody closer has anything then i will be in touch.

as for the ratio. the diff i had come off a 1.6 g plate pinto sierra. but to be honest any ratio is better than no diff. (is it gonna make a big difference on a 1.6?)

[Edited on 2/7/09 by ashg]

geoff you have u2u

i have a spare diff what diameter are the shafts you have.. and waht ratio you looking for...

will check tonight for you if your interested

ratio isnt that important to be honest. i will pop out and measure the ends that push into the diff

the diameter of the shaft that pushes into the diff is 28mm thats measuring the unsplined bit.

[Edited on 2/7/09 by ashg]

will try and get in the shed tonight and let you know...

if not im off work tommorrow so will check then

cheers for all the help guys Geoff come to the rescue. i drove up to cambridge this afternoon and collected.

cheers geoff your a star. was nice to see your car too.