Hopefully, there will be at least one LCB-er who has info on this stuff.

I need plastic edging trim, to cap the seating area side rails. Fitting width - 29mm, with suitably radiussed outer edge, so hockey-stick type extrusion section would be OK.

Have Googled various sites in UK, but nothing suitable found. Does anyone know of possible source?

[Edited on 22/5/13 by Dick Axtell]

Not this stuff?

Small black rubber car edge trim | eBay


[Edited on 22/5/13 by deanspoors]

I think he's thinking more along the lines of this stuff, but in plastic:

http://www.clickmetal.co.uk/Angle-Types/Mouldings/Aluminium -Cope-Mouldings/p-16-8-16/

Baines, Tunbridge Wells will sort you out.

http://www.coh-baines.co.uk/

You can get various wooden mouldings from diy stores.i did the edge of my cockpit and tunnel with some profiled angle from wickes. Sanded back and then sprayed black for the curved shoulder bars I used wheel arch trim from cbs.

Thank you All, for your suggestions. Will check them out.

The Cope Moulding description seems to apply more specifically to what I need, rather than "edge trim".

I got some dome top in aluminium from B&Q, one length did both sides.