My Hazard switch is playing up on the Locost. The ratchet mechanism is wearing and it won't stay latched down correctly and causes the indiactors to not work. If I push the hazard switch in a tiny amount then they work fine.

So has anyone out there got the stalk unit kicking around in the dust anywhere?

Cheers.

mine did the same.

I took the red cover off and pilled the bidy out of the column.......then gently with a toothbrush and wd40 gave it a good clean and it worked as good as new!

Dirty gets embedded in the moulded plastic "tracks" which the latching pin follows....it's probably this causing the problems,

I already did that chap, stripped the whole unit down and cleaned/lubricated everything.but it looks like the 'V' in the latching part is wearing, and the button comes up a little too far when latched in the 'down-off' position. So when I press it down just a fraction of a mm the indicators work fine.

I guess I may be able to 'weld' a little plastic back in and shape it to see if that works?

Bump