does anyone know if there is a kit for moving the gearlever back on type 9 sierra box?

cheers

boggle

here link to Rally Design

There is that, but I found I got a reasonable position by shifting the engine+gearbox as far to the rear as I could. I ended up with about 2cm space between the bellhousing and the tunnel, and I had to cut out a small cross-piece on the tunnel, but now it clears the dashboard just fine.

thanks guys...

Theyr on ebay aswell. Just search locost and theyl come up.

As above though i have put my engine as far back as i can which helps with weight distribution and has placed the gear lever nicely.

i will post some pics up later as to where it sits at the mo....im not over happy with its position..

I wanted mine further back 6" so made my own, not that difficult, pictures in my gallery.

Cheers

Rich

rich, couldnt see any pics, could you let me know whats needed to make your own, goin to give it a go in a few weeks. dont fancy spendin £50.

also i think i have seen a guide somewhere to make your own?

Here are some picture from my gallery page 8 using the big picture below.








Cheers Rich


[Edited on 4/1/10 by RichardK]

brilliant, cheers.

My design is very similar - a little simpler, but I wasn't trying to extend quite so far.



An outline of my construction method is shown on my web pages (blue "WWW" button below).

Cant find 1 for my T5 cossie box