I'm sortin out an exhaust for now whilst I get one built.

What's the best way to fit 4 exhaust manifold bits to new bits?

I thought a swager would be cheap ermmm no.

I can't weld that well so don't wanna so that....

I saw some adaptor a to join pipework which are £12 each well it's only for a day at a track day then ill get a new exhaust.

Help please peeps .....



[Edited on 7/2/13 by jossey]

David are you talking about joining straight tubes with something like this eBay Item or a collector to take a new manifold own to an exiting exhaust pipe like this eBay Item

Rich

Sorry I was a little unclear. Yes joining my old manifold which is cut up to new pipe. So the first connector should work.

Thanks rich





David

Yes but I would suggest you use Mikalor stainless steel T-bolt clamps rather than U-bolt clamps.

Ok will do.

Thanks