Board logo

Drive shaft making
madrallysport - 29/8/15 at 12:45 PM

Is there any one on here who can make drive shafts.

Either complete shafts or even join shafts for me.

I'm in need of vauxhall inners with mini outers, i have all shafts needed already, so would like to go the joining way if possible.

Thank you

T66 - 29/8/15 at 01:30 PM

Berrisford.co.uk

daniel mason - 29/8/15 at 02:21 PM

Ian Dayson at force!

redturner - 6/9/15 at 06:59 PM

Wilson Bros in Bulwell Nottingham. They will balance them as well. Done lots for me.....

MikeR - 6/9/15 at 07:50 PM

What sort out price do Wilson charge?

redturner - 6/9/15 at 08:11 PM

The work that you want doing I would say, reasonable. They used to do all my commercial vehicle big stuff when I was working and if they hadnt been the right price they wouldnt have got the work. They are only just off Jtn 26 M1 so have a run up and see them, its not far from you really.
RedT...

Paul Turner - 8/9/15 at 09:29 AM

quote:
Originally posted by redturner
Wilson Bros in Bulwell Nottingham. They will balance them as well. Done lots for me.....


Used them to fit me 2 new UJ's and a new front yoke earlier this year. Fine job.

When I collected it I spotted that the large clump of balance weights that had previously been fitted when the prop was new 23 years ago had gone, asked why. Told simply that after they had straitened it there was no need for the weights. Obviously fitting weights was easier than doing the job correctly all those years ago.

No issues at all and much less than a new prop. Would use again.