Board logo

Crossflow Oil Pressure Sender thread size
viatron - 5/4/06 at 11:20 AM

Not near the workshop and need to order and adapter to fit the telimetrics 1/8" NPt thread into the oil pressure sender hole in the crossflow block, anyone know what thread and size the original sender is?
Mac

02GF74 - 5/4/06 at 11:32 AM

It looks to be the same size as the water temp sensor; sorry, duno size

stevebubs - 5/4/06 at 01:11 PM

If it's not 1/8 NPTF then it's 1/4 BSP


[Edited on 5/4/06 by stevebubs]

stevebubs - 5/4/06 at 01:20 PM

quote:
Originally posted by David Jenkins
i think it's 1/4 NPTF, but don't spend any money until you get confirmation.


Yep - hence my BSP comment (similar threads).

Adapters available from Think Auto, Burton Power, etc... best mounted on the end of a bit of rubber tubing to isolate from vibration.

David Jenkins - 5/4/06 at 01:21 PM

Ring Burton Power and ask them - that's what I did!

02GF74 - 5/4/06 at 02:44 PM

quote:
Originally posted by David Jenkins
Ring Burton Power and ask them - that's what I did!


so what did they say?

David Jenkins - 5/4/06 at 02:59 PM

Too long ago to remember! If you can wait until tonight then I can see if I've got the receipt... but I suspect that's too late for 'viatron'.

David

[Edited on 5/4/06 by David Jenkins]

viatron - 5/4/06 at 04:47 PM

Cheers all, bit the bullet and and ordered 2 different sizes just to be sure!!
Mac