FASTdan
|
| posted on 19/6/09 at 01:08 PM |
|
|
alu tube on bike carb mani's
can anyone tell me what sort of thickness wall tube is used on the manifolds for bike carbs - eg bogg bros?
|
NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
|
|
|
tegwin
|
| posted on 19/6/09 at 01:14 PM |
|
|
Assuming a N/A engine... I would use 1.6-2mm alloy ....
Its really just got to be strong enough to support the bits and pieces...
------------------------------------------------------------------------------------------------------------------------
Would the last person who leaves the country please switch off the lights and close the door!
www.verticalhorizonsmedia.tv
|
|
|
welderman
|
| posted on 19/6/09 at 01:17 PM |
|
|
i prefer to use 2mm alloy, its better to get a good weld on too.
Joe
Thank's, Joe 
I don't stalk people
http://www.locostbuilders.co.uk/forum/23/viewthread.php?tid=172301
Back on with the Fisher Fury R1
|
|
|
kipper
|
| posted on 19/6/09 at 02:27 PM |
|
|
.
2 inch alloy scaffold tube
Denis Aka........Denis.
Where did that go?
<<<<
|
|
|
