ChrisW
|
| posted on 28/1/06 at 06:45 PM |
|
|
Mazda RX6 rear calipers
Has anyone changed the rear pads on a Mazda MX6?
Managed to do the nearside and found the screw that winds the hand brake back behind a bolt in the rear of the caliper. However, on the offside, the
hole for the screw is there, but there is no screw in it. I assume this must be 'how it should be' as otherwise fluid would leak out, but
I'm stumped as to how to wind the piston back on that side.
Anyone shed any light so I can get the thing out of my workshop?
Cheers, Chris
|
|
|
|
|
ceebmoj
|
| posted on 28/1/06 at 06:52 PM |
|
|
hi,
on the mx5 rear caliper you un screaw the cap over the wind back bolt an in ther is a spesal tool that slots in ther to to the caliper winding back
with this bit can be taken out of one side and used on the other.
|
|
|
phelpsa
|
| posted on 28/1/06 at 07:44 PM |
|
|
Arent MX6s just a ford probe underneath?
Hope that helps somewhere 
Adam
|
|
|
