hi,

after redoing my transmission tunnel in carbon sheet that i have spare.

what do people use for edging trim looking for 90 degree maybe 1mm alloy of something like that?

Ally Cope moulding is common, but usually thicker (2-3mm) and about 20x5mm.
http://www.clickmetal.co.uk/Angle-Types/Mouldings/Aluminium-Cope-Mouldings/p-16-8-16/

Just out of curiosity where did you get your carbon sheet for the tunnel top? And is it real carbon or carbon effect? Looking to do the same in my mk indy

I think I have spare J profile Ali extrusion in the garage. I am away until the weekend, but if you can wait, I will check what I have....?

I thought that this was a clever solution

From
http://www.locostbuilders.co.uk/forum/50/viewthread.php?tid=194553&page=10

http://s133.photobucket.com/user/corsaboss/media/October%2015/1799FBB7-4452-4035-BCD1-83162012AB35.jpg.html

http://s133.photobucket.com/user/corsaboss/media/October%2015/111E4AB9-A69E-435E-A455-1A49103DCE3D.jpg.html

[Edited on 9/12/15 by Toys2]

[Edited on 9/12/15 by Toys2]

quote:

---

Originally posted by twybrow
I think I have spare J profile Ali extrusion in the garage. I am away until the weekend, but if you can wait, I will check what I have....?

---

quote:

---

Originally posted by Toys2
I thought that this was a clever solution

From
http://www.locostbuilders.co.uk/forum/50/viewthread.php?tid=194553&page=10

http://s133.photobucket.com/user/corsaboss/media/October%2015/1799FBB7-4452-4035-BCD1-83162012AB35.jpg.html

http://s133.photobucket.com/user/corsaboss/media/October%2015/111E4AB9-A69E-435E-A455-1A49103DCE3D.jpg.html

[Edited on 9/12/15 by Toys2]

[Edited on 9/12/15 by Toys2]

---

Hi
We used kitchen worktop end trims
They have a nice radiused edge & you can use them
either way, wide section to top or sides


Interior trim

Good luck

[Edited on 10/12/15 by renetom]