Board logo

FS. Lotus 23 Project
femster87 - 17/9/16 at 06:27 PM

As above, i acquired this a while back. It is a long term project. But I might have to move with work early next year. So I am clearing out the workshop slowly in anticipation

3000 ono. Chassis and Bodywork. I have all the suspension bits apart from the rear upright ( I have one but it a fabricated one. not too pretty) I have some drawings that a new one can be made from. All the panel rivet holes have been welded back up and flattened on the chassis.

I will try and sell until the end of October, If it does not go, I have a slot to have it built to rolling chassis .

I have the floor panels laser cut.I have drawings for the most of the remaining panels and can help cut them. I have the pedals and a steering rack for it.
I have acquired quite alot of stuff which is available to the buyer by negotiation

I have an NG3 transaxle available for sale as well (600). I can source the adaptor to bolt this onto a C20XE engine. They adaptors around 350 from banks europa,





Description
Description


Description
Description


Description
Description


Description
Description


Description
Description


GavMax - 17/9/16 at 07:27 PM

Hi Femster
Dropped you a UTU
Thanks
Gavin


brookesy - 20/9/16 at 03:55 PM

I have an unused Banks NG3 to C20XE which I can let go for half that price.

I also have a pair of 23 uprights I could be persuaded to part with.

[Edited on 20/9/16 by brookesy]


TimC - 20/9/16 at 04:27 PM

I would love that with a Saab B204 Turbo in the back.

One at a time though Tim...


sevaun - 14/3/19 at 01:20 PM

What happened to this, was it sold on? Built?


femster87 - 14/3/19 at 05:56 PM

In build, do you want to buy it? Spec has gone up considerably


sevaun - 15/3/19 at 08:51 AM

Femster you have U2U