I have approx 30 to 40 mill cutters ranging from a few mm in diameter up to about 30mm diameter.
If anyone is likely to be interested on here I will catalogue all of the sizes, ideally i would like to sell as a job lot but I have no idea on the
value of these ??
All pretty much brand new looking.
I am in North Hertfordshire if anyone would like to come & look or I can go through them, add sizes on here & photograph if there is any
interest.
Cheers
[Edited on 25/6/17 by Andybarbet]
Depends on what they are - shank type, any carbides, anything weird (profiles, chamfer bits etc)?
I'd be interested in cutters that fit a smaller mill
I'll PM you
Thanks
Gavin
I think they are all flat cutters but I will try to get some more details in the next couple of days.
Cheers
i would be interested too