I am on the look out for a Duratec Head (2lt) as a project head to work on. I have a set of kent cams/springs to go in it. Ideally it will be a good used high port head (see http://www.sbdev.co.uk/Duratec/Cylinder%20Head.htm) ready for a complete refurb but anything considered.

What have you go?

I do, I have one from a 2009 Focus with 8,000 on it. It’s the high flow/high port casting.

I actually have the whole engine, burns a bit too much oil and needs a rebuild / piston rings.

[Edited on 18/12/19 by se7ensport]

All sorted, don't you just love Locostbuilders