Board logo

momo 70mm to mountney 100mm sterring adaptor
Magh - 16/8/20 at 08:42 AM

Morning, as usual every job on the kit escalates. I picked up a QR so purchased a new momo hub to allow this to fit. Now my steering wheel is a mountney with the 6x100mm pcd so looking for an adaptor to go from 6x70mm momo to the 6x100 mountney traditional fitting.

The only ones i can find online are from B-G racing etc come in at £60 plus for a little plate, i can find loads for £10-25 but there are all the 3 bolt pcd adaptors.

Does anyone know of a cheaper one i require or have one lying around they wish to sell?

Thanks Mike.

MikeR - 16/8/20 at 02:15 PM

I've looked many times. I think I did find one for 20 quid. Will look again and post a link of I can find it. I keep thinking how much could it cost to get one made,, but never ask anyone.

Magh - 16/8/20 at 04:14 PM

That would be great if you could. I would of thought there was quite a market for such an adaptor.

MikeR - 16/8/20 at 04:21 PM

Sorry, this is the best i found

https://www.europaspares.com/hub-adaptor-plate-mountney.html

TimC - 17/8/20 at 07:20 AM

I may have what you need. Will check this evening.

Magh - 17/8/20 at 06:31 PM

Thank you very much TimC 🤞

fazerruss - 17/8/20 at 07:22 PM

If you can't get one off the shelf I can make one to dimensions.

TimC - 18/8/20 at 12:15 PM

quote:
Originally posted by Magh
Thank you very much TimC 🤞


Sorry - on checking I have 4x68mm to 6x100 Mountney.

Looking back, I drew it and then had it cut by https://www.octagonprecision.com for about £25 delivered.