Whats the best / cheapest wideband sensor to use in a zetec when logging and can it be left in place when completed.
Cheers Mike.
Hmm I have a self built JAW, cheap but support is pretty rubbish and took a few goes to make a success of it, if I knew what I know now I would get an
LC1
Once on the car you can leave in place, or remove its up to you although I am not sure why you would remove it.
lc-1 is worth the investment
I would say Tech-Edge.
marcel.
I got an LC-1 shipped from the US.
It is great. You can leave it in permanently.
Matt
quote:
Originally posted by Benzine
Techedge vs LC-1
I have an LC-1 which is permanently connected to my MS for closed loop on output 1 and a DB gauge on the second output.
It works fine.
No problems at all.
quote:
Originally posted by matnrach
I have an LC-1 which is permanently connected to my MS for closed loop on output 1 and a DB gauge on the second output.
It works fine.
No problems at all.
I have an LC1, never had a problem. However I run in open loop and only connect it for datalogging as I think it looks naff sticking out the top of the external exhaust.
Techedge has worked fine for me.....
Only gripe...I bought the digital display which has broken after getting a little wet....
Paul.
Tech Edge would be my first choice, quality of design and support is first rate.
The Innovate products are pretty good too, but there have been quite a few failures of the heating circuit in the LC1.
My JAW sits in a box of other bits of electronic junk, exactly where it belongs.
[Edited on 11/8/09 by MikeRJ]