Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: ATSPEED > Recommended!
blockhead_rich

posted on 5/5/11 at 09:33 PM Reply With Quote
ATSPEED > Recommended!

Hi folks,

I've just had my car set up on the Rolling Road @ ATSPEED. On the short(ish) journey home, my car is now transformed, much better to drive, so thanks a lot for the excellent service and attention to detail (they even spotted a problem which could have been serious, that I had never even noticed in 4 years of it being on the road)!.

A great bunch and thoroughly RECOMMENDED to all!!! It's great to be able to report good service for a change, eh.


See you soon guys and I'll let you know how it goes after a bit more driving

Rich

P.S. I'll do some searching now for ways to improve the inlet on my ST 4AGE 20v engine..... and hopefully I'll find a (cheapish) way to gain some more horses!

View User's Profile E-Mail User View All Posts By User U2U Member
RazMan

posted on 5/5/11 at 09:43 PM Reply With Quote
Glad you got sorted Rich - I hope to have a similar experience soon





Cheers,
Raz

When thinking outside the box doesn't work any more, it's time to build a new box

View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
atspeed racing

posted on 6/5/11 at 06:20 AM Reply With Quote
Thank you for the recommendation Richard.
Glad that the dyno work complimented a well built car with such good attention to detail.
Would be interesting to hear if the fuel consumption has improved and by how much.

NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
View User's Profile View All Posts By User U2U Member
blockhead_rich

posted on 6/5/11 at 06:58 AM Reply With Quote
I'll let you know about the fuel consumption.

I'll have to look into the thermostat too. Guage read about 80 on the way home so it's a little low but previously it can get to the right temp (95) when in slow traffic / or in town after a run. Can you remember, did the guage read the same as the ECU / engine temp sensor during mapping or do I need to check this first (easier job than changing the thermostst as the engine is a bugger to get the air out of the cooling system)?

Rich

View User's Profile E-Mail User View All Posts By User U2U Member
atspeed racing

posted on 6/5/11 at 04:18 PM Reply With Quote
I didnt notice anything wrong with either of the temp read outs.

Ian

NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.