theprisioner
|
| posted on 12/2/12 at 05:21 PM |
|
|
Puma Tacho - J15
I would ideally like to use the Rally Design RMD gauges in my Sylva J15. I have a Tacho output on the EMU/ECU pin (48) that runs to the instrument
cluster and directly to the above unit. Can anybody tell me if the specs of the Ford EMU and a after market Tacho are compatible.
I phoned Rally Design but the chap could only quote the settings on the rear like 4/6/8 cylinders. A calibration pot. An indication that it wires on
to the primary of the coil if you have one. What happens with Ford wasted spark! No reply!
I could take a simple pulse generator and work out a bit more of the picture like the number of pulses and their amplitude per 1000/revs but that
would only be useful if I had the same information about the RMD gauge.
Any ideas?
|
|
|
|
|
will121
|
| posted on 12/2/12 at 05:56 PM |
|
|
I can't answer your specific question, but I use a standard fiesta rev counter with my emerald ecu on problem and have now swapped it to am
after market lcd rev counter with the same ecu feed with no problems
|
|
|
big_wasa
|
| posted on 12/2/12 at 06:46 PM |
|
|
I use an after market gauge with my eec-v I just cant remember what I set it to.
|
|
|
monkeyarms
|
| posted on 13/2/12 at 11:12 AM |
|
|
I have ETB gauges - the rev counter is connected to one of the coil pack wires, easy.
 
Description
|
|
|
