franky
|
| posted on 9/4/12 at 08:40 PM |
|
|
Engine machining costs/where?
Been stripping an engine down i'm fitting in my 240z.... Its a Datsun/Nissan L28(2.8 IL6) SOHC.
How much would I be looking at for;
Block dip+clean
6 cylinder 1mm overbore
Crank regrinid(very very slight wear on the bearings/crank)+ balance, lighten
Also where would you all go in the Lincs/Notts/derby area?
|
|
|
|
|
Thinking about it
|
| posted on 9/4/12 at 08:58 PM |
|
|
I paid £50 for the re bore and hone.
£60 for the crank regrind.
That was for a 4 cylinder 5 bearing crank.
The clean was thrown in.
[Edited on 9/4/12 by Thinking about it]
|
|
|
Slimy38
|
| posted on 9/4/12 at 08:58 PM |
|
|
Possibly a little bit far south, but my last head work got done by SEP at Kegworth. I was really impressed with their work. I got referred to them by
an old racer who used to take all his engines there for blueprinting etc.
See what they can do for you, SEP Kegworth.
I don't know about prices though.
|
|
|
Trollyjack
|
| posted on 9/4/12 at 09:09 PM |
|
|
Bit too far North but give these guys a call
Link
Had rebore done + recon head here resonably priced
TrollyJack
|
|
|
Volvorsport
|
| posted on 9/4/12 at 09:42 PM |
|
|
east lincs motorsport , doesnt need to advertise !!!
done my volvo stuff ace and cheap .
www.dbsmotorsport.co.uk
getting dirty under a bus
|
|
|
Peteff
|
| posted on 9/4/12 at 09:45 PM |
|
|
Cotterell is my local and they are quite reasonable.
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
|
