Jonte
|
| posted on 3/1/08 at 09:24 PM |
|
|
MK seats and runners *sigh*
I must check some things about the runners and seats from MK
If I measure the distance between the holes in the runners its 330mm, but when I measure the runner fixings in the seats it´s 310mm 
Is this how it is for everyone and you just redrill the runners?
Then I probably have to make some 10mm brackets under the runners
Click it
|
|
|
|
|
StevieB
|
| posted on 3/1/08 at 09:56 PM |
|
|
That's pretty much what I've done.
I used some 12mm thick rubber washers I picked up at an autojumble as spacers - should take a little of the vibration of of the seat too.
Wouldn't it be nice f a little forethought to these little things was displayed by the manufacturers?
[Edited on 3/1/08 by StevieB]
|
|
|
Avoneer
|
| posted on 3/1/08 at 09:59 PM |
|
|
But the vibrations are nice ;-)
Yep - ovalate or re-drill the holes.
Pat...
No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.
|
|
|
Hellfire
|
| posted on 4/1/08 at 07:16 AM |
|
|
quote:
Originally posted by Avoneer
But the vibrations are nice ;-)
Yep - ovalate or re-drill the holes.
Pat...
Concurr with what Pat says - but dont read it as ovulate, you dont want one more bad tempered person in the house... 
Steve
|
|
|
scotlad
|
| posted on 4/1/08 at 08:08 AM |
|
|
Quote-
'Concurr with what Pat says - but dont read it as ovulate, you dont want one more bad tempered person in the house... '
Ha Ha Thats what i thought of too- ones enough for me!!!!
Wonderous is our great blue ship that sails around the mighty sun, and joy to everyone that rides along!
|
|
|
ASH3
|
| posted on 4/1/08 at 10:42 PM |
|
|
More holes in the floor the better
[Edited on 4/1/08 by ASH3]
|
|
|
Jonte
|
| posted on 6/1/08 at 07:18 PM |
|
|
well I guess you were lucky or you don´t remember it correctly . But the holes on my runners are the same distance on both sides.
Click it
|
|
|
pawgrp
|
| posted on 8/1/08 at 02:23 PM |
|
|
Hi Jonte,
There is a mark on the runner which just happens to be the right distance for the hole centers for the seat. Just run a tape along it from one of the
pre drilled holes and I'm sure all will become obvious.
Paul
|
|
|
Peteff
|
| posted on 8/1/08 at 05:03 PM |
|
|
Ovalise or elongate
or a mixture of both?
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
|
%20(WinCE).JPG)
