Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: central heating plumbing question
mads

posted on 28/10/12 at 07:19 PM Reply With Quote
central heating plumbing question

evening all,
could someone have a look at the following pic and tell me what the purpose of the stopcock is in this setup? and should it be open or closed?


water pump
water pump


the top pipe in the pic comes from the 3-way actuator above the water pump and goes into the water tank. the bottom pipe also comes out of the water tank but then feeds back into just above the water pump.

cheers,

mads

[Edited on 28/10/12 by mads]





We gain knowledge faster than we do wisdom!

Life is not a journey to the grave with the intention of arriving safely in a pretty and well-preserved body, but rather to skid in sideways, thoroughly used, totally worn out and loudly proclaiming... "f*ck, what a trip!"

View User's Profile Visit User's Homepage View All Posts By User U2U Member
tegwin

posted on 28/10/12 at 07:46 PM Reply With Quote
Usually done as a balance valve to insure a minimum flow through pump etc even if all radiators are off. Usually set halfway between open and closed depending on system





------------------------------------------------------------------------------------------------------------------------
Would the last person who leaves the country please switch off the lights and close the door!

www.verticalhorizonsmedia.tv

View User's Profile Visit User's Homepage View All Posts By User U2U Member
Peteff

posted on 28/10/12 at 09:32 PM Reply With Quote
You'd still get flow through the pump with the radiators off unless you were running a single pipe system. If it's closed you will get no domestic hot water.





yours, Pete

I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.

View User's Profile View All Posts By User U2U Member
adam1985

posted on 28/10/12 at 09:41 PM Reply With Quote
Bypass if all rads are shut the pump will be pushing against it with nowhere to go should be slighty open.

Eta you would still get a flow on a 1 pipe system but not a conventional 2 pipe so wouldnt have this on 1 piper

[Edited on 28/10/12 by adam1985]

View User's Profile View All Posts By User U2U Member
mads

posted on 29/10/12 at 10:18 PM Reply With Quote
thanks for the replies folks. so follow up question is, if this valve was fully open, should it affect the downstairs radiators and stop them getting hot? that is what seems to have happened. I closed the valve fully and the bottom radiators are working again.





We gain knowledge faster than we do wisdom!

Life is not a journey to the grave with the intention of arriving safely in a pretty and well-preserved body, but rather to skid in sideways, thoroughly used, totally worn out and loudly proclaiming... "f*ck, what a trip!"

View User's Profile Visit User's Homepage View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.