Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: 306 MOT fail on brake light problem
cadebytiger

posted on 18/11/07 at 01:52 PM Reply With Quote
306 MOT fail on brake light problem

Hey there.

Sorry this is a bit off topic but the kit in the garage now and i have gone back to using my pug 306.

It has just failed it's MOT because when the indicators are switched on with the brake light on also the brake light dims with each flash of the indicator.

I am thinking it sounds like an earth problem but the light cluster earth wire runs off into a bunch of wires and then god knows where it goes.

I have cleaned up tow earths in the engine bay to no effect.

Any ideas would be more then welcome!

Thanks again

Rupert

View User's Profile View All Posts By User U2U Member
Danozeman

posted on 18/11/07 at 01:54 PM Reply With Quote
Clean up the earthing points in the boot and the contacts on the light cluster. IIRC there are some on the reare panel and up near the strut tops.





Dan

Built the purple peril!! Let the modifications begin!!

http://www.eastangliankitcars.co.uk

View User's Profile View All Posts By User U2U Member
dan__wright

posted on 18/11/07 at 02:08 PM Reply With Quote
rear lights will be full of water causing a short, common problem, also happenes on the 106.

take but bulbs / holders out and test again, will work fine.

empty lights out and drill a few smal holes on the bottom for water to drain

View User's Profile View All Posts By User U2U Member
rusty nuts

posted on 18/11/07 at 02:19 PM Reply With Quote
After cleaning the rear light cluster terminals I would also run an additional earth wire for each rear light.
View User's Profile View All Posts By User U2U Member
Kook

posted on 18/11/07 at 02:27 PM Reply With Quote
I added a earth point to my old 306 when it was doing the same and connected new wires to the new earth point and it was ok after this.
View User's Profile View All Posts By User U2U Member
Peteff

posted on 18/11/07 at 03:17 PM Reply With Quote
It can happen if you force a stop and tail bulb in the wrong way round as well.





yours, Pete

I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.

View User's Profile View All Posts By User U2U Member
cadebytiger

posted on 19/11/07 at 05:41 PM Reply With Quote
thanks for all your help

I have made new earths for both sides and they are good. This has sorted the left side but right i still playing up.

Tryed cleaning the connections *no water in there BTW) but still no joy! I will check the bulb types tonight

Thanks again

Rupert

View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.