piddy
|
| posted on 20/1/06 at 06:57 PM |
|
|
clutch delay
I’ve got a bit of a problem.
I am at the stage of fitting the engine (1.8 Zetec 105bhp) and gearbox (Ford type 9) together.
The splined shaft on the type 9 doesn’t fit into the Clutch plate.
I did a search on here and found this thread; Zetec Clutch therefore went and
brought a clutch assembly for a 130 BHP 1.8 Escort Zetec. However this will not fit the fly wheel (bolt holes pattern are spaced out to far)
I would guess the Mondeo and Escort clutch assembly are the same bolt hole pattern..
Doe’s this mean I now need to go and get a Zetec 130 BHP fly wheel?
How much should I expect to pay for a flywheel?
Would a 1.8 CVH or Pinto flywheel be the same?
[Edited on 20/1/06 by piddy]
|
|
|
|
|
britishtrident
|
| posted on 20/1/06 at 07:31 PM |
|
|
What did the engine come out off and what dia clutch was originally fitted ?
Use a cover plate as per original and use the QH clutch online catalog to pick a driven plate either the same size or slightly smaller with the
correct 25.4x23 spline
http://www2.qha.com/catalogue/downloads.asp
|
|
|
piddy
|
| posted on 20/1/06 at 07:57 PM |
|
|
Engine came out of an XR3.
I will take a look on the links thanks.
|
|
|
rusty nuts
|
| posted on 20/1/06 at 09:39 PM |
|
|
I have an 1800 Zetec flywheel you can have for a fiver if it is the right size for you . Its in Shelford near Cambridge .
|
|
|
piddy
|
| posted on 21/1/06 at 12:53 PM |
|
|
Hi.
I've sent you an U2U.
|
|
|
rusty nuts
|
| posted on 21/1/06 at 05:59 PM |
|
|
Piddy, you have u2u
|
|
|
.jpg)
